Key Chain Experiments #2

Use INCHES for all keychain experiments

1) Make pentagon, by using the polygon tool and setting sides to 5, then dimension the radius to 2 inches

2) Make the point coincident with the vertical access, should be fully defined. Make sure that the pentagon is centered from the origin.

3) Create a 0.5 inch offset.

4) Extrude the offset 1.25 inches

5) Extrude the center 0.75

6) Now let’s add a point which will be used for step 7.

7) Add a hole , set the depth to 0.75 so it goes all the way through :

8) Now add a pattern. Your initials or something else to your keychain